STANDARD BRACE KIT
Our revised standard brace kit design (previously known as the reduced clearance brace) works on all 2015 and newer Dodge Challenger and Charger models including the Hellcat, Demon and Redeye. Kit includes steel brace, rubber isolator pad, hardware, Loctite and decal.
- 1/4″ US-made steel construction
- Utilizes OEM differential case bolts
- Access to differential filler plug without removing brace
- Available in gloss black or brake caliper red
This brace kit will work with all aftermarket exhausts.
TECH UPDATE! – Torque Specs
The purpose of this update is to provide torque spec information for the differential main case bolts for our current brace line-up.
The main case bolts are to be torqued to a minimum of 80 ft./# and up to up to 90 ft./#’s if desired. Due to variances in design and strength of crows-foot socket heads, achieving 80 ft./#’s is not always attainable without the socket head flexing off the bolt head. In those instances, torque to 50 ft./#’s and then switch to a high quality open end wrench (extended if possible) and rotate the bolt another 100-120 degrees to attain a torque spec of 80-90 ft./#’s.
We are asked frequently about a torque spec for the cross-member bolts and there is not one. Tighten those bolts until there is a consistent squeeze (1mm bulge) across the rubber isolator. After initial installation, check tightness after 100 miles and regularly after that based on the level of track/roll/drag racing you participate in. It is not uncommon for the differential to “settle” in and require fine-tune tightening of the cross-member bolts.
Please contact us for any additional questions at [email protected] Check your spam folder if you do not see a timely response in your inbox.
Use of an aftermarket brace will impact the manufacturer’s warranty on the differential. Purchaser assumes all responsibility for installation and use.